![]() ![]() Run the following commands in a terminal:Ĭd calibre* & sudo python3 setup.Install the various dependencies listed below.Make sure your system has Python 3 installed.If you're still determined to install from source, read on: Please do not open bug reports or expect any form of support. If you install from source, you are on your own. ![]() Sudo mkdir -p /opt/calibre & sudo rm -rf /opt/calibre/* & sudo tar xvf /path/to/downloaded/calibre-tarball.txz -C /opt/calibre & sudo /opt/calibre/calibre_postinstall Source install WARNING: calibre is a highly complex piece of software with lots of very finicky dependencies. Assuming you want calibre in /opt/calibre, run the following command, changing the path to calibre-tarball.txz below as appropriate: If you wish to revert to an earlier calibre release or download a calibre upgrade manually, download the tarball of that release from here (choose the 32-bit or 64-bit version, as appropriate). Sudo -v & sudo calibre-uninstall & wget -nv -O- | sudo sh /dev/stdin version=4.23.0Ĭhange 4.23.0 above to whatever version you want installed. You can install a previous calibre release, like this: Wget -nv -O- | sh /dev/stdin install_dir=~/calibre-bin isolated=y You can also do an "isolated" install that only touches files inside the installation folder and does not need to be run as root, like this:.Sudo -v & wget -nv -O- | sudo sh /dev/stdin install_dir=/optĬhange /opt above to whatever folder you want calibre automatically installed to. You can change the folder calibre is installed into from the default (/opt) like this: ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |